- Should you remove lath and plaster?
- Is lath and plaster better than drywall?
- When did they stop using lath and plaster?
- How far apart are studs in lath and plaster walls?
- Can you put drywall over lath and plaster?
- Do stud finders work on lath and plaster walls?
- Is lath and plaster dangerous?
- Can you mount a TV on lath and plaster?
- What is the best stud finder for plaster walls?
- How much weight can plaster walls hold?
- How much does it cost to replace plaster with drywall?
- How much would it cost to drywall a 1500 sq ft house?
- How do you find studs in old lath and plaster walls?
Should you remove lath and plaster?
As long as they’re in decent condition (not falling away from the lath in chunks), you may opt to leave them as they are.
For many, plaster walls are a big part of an older home’s historical charm, and they’re well worth keeping intact..
Is lath and plaster better than drywall?
Lath and plaster walls provide a room with better soundproofing, as opposed to drywall walls of an ordinary thickness (1/2-inch). Soundproof drywall, though, rivals lath and plaster walls in terms of soundproofing. Lath and plaster walls have a slightly better insulating R-value than do drywall wall systems.
When did they stop using lath and plaster?
Lath and plaster was a skilled craft and a time-consuming technique and the advent of cheaper, mass produced, pre-manufactured plasterboard meant lath and plaster largely fell out of favour by the 1930s and 1940s.
How far apart are studs in lath and plaster walls?
You may wonder, how far apart are studs in my home? They’re always spaced either 16 or 24 inches on-center (measured from center to center) along the wall and run between the floor and ceiling. Drywall or lath (for plaster walls) attaches to the edge of the studs.
Can you put drywall over lath and plaster?
If the plaster walls in your home are unattractive or too costly to repair, you can cover them with drywall and start fresh. … Scrape any crumbled plaster off the lath and fill the resulting hollow with a patch of drywall. Once old plaster is stabilized, the walls are usually sound enough for new drywall.
Do stud finders work on lath and plaster walls?
Because standard stud finders detect a change in density inside the wall, they don’t work on lath and plaster — the density inside these walls is not constant enough. If you have just moved into an older home and your stud finder isn’t doing its job, invest in a metal scanner instead.
Is lath and plaster dangerous?
Watch out: even if the plaster does not contain asbestos, the silica dust that is created during sawing or grinding or demolition is a respirator hazard, particularly at higher levels. Watch out: also, that metal lath will give a nasty cut if you don’t wear heavy gloves when handling it.
Can you mount a TV on lath and plaster?
You most certainly can mount this on lath and plaster walls. The key is finding the studs – and honestly finding the center of the studs. The mount itself is really heavy, and then you’re putting a heavy television on the end of a long lever.
What is the best stud finder for plaster walls?
Zircon MetalliScanner m40Zircon MetalliScanner m40 Our selection as the best stud finder for plaster walls isn’t technically a stud finder—it’s a metal detector. In our experience, metal detecting gives us the best results. The Zircon MetalliScanner m40 is able to detect metal in a variety of materials, including plaster.
How much weight can plaster walls hold?
Your wall will be able to take as much weight as you can hang on it. Every 12″x12″ span of 1/2″ drywall can hold 40lb in pull out load, as if you were hanging from a ceiling. The other type of load is shear or pull down load.
How much does it cost to replace plaster with drywall?
The cost to remove plaster and replace with drywall ranges from $1.60 to $3.80 per square foot. This includes $0.50 to $0.80 per square foot for demolition and $0.10 to $0.20 per square foot for disposal.
How much would it cost to drywall a 1500 sq ft house?
Average Cost to Drywall a House by House SizeCost to Drywall a 1000 sq ft HouseTotal CostCost to Drywall a 1500 sq ft HouseLow x 5500 square feet$7,975Average x 6325$12,10016 more rows
How do you find studs in old lath and plaster walls?
Grab the strongest magnet you have and tie a piece of dental floss or string around it. Dangle the magnet against the wall and slowly move it horizontally across the wall. You have to go slow. Every so often, the magnet will stick to the wall a bit on the stud location.